56
The systolic pres-
sure Value or
diastolic Pressure
value too high
1.The cuff was held
lower than your heart
Keep correct position
and
measure again
2.The cuff was not
attached properly
3.You moved your
body or spoke during
measurement
The systolic
pressure value or
diastolic pressure
value too low
1.The cuff was held
higher than your heart
2.You moved your
body or spoke during
measurement
The functionality of this device may be disturbed by the use of strong
electromagnetic elds such as mobile phones or radio stations at close
range, so we recommend that these devices be kept at least 1 m away.
In cases where this is inevitable, please make sure that the device
is working properly before use. If you are suffering from a heartbeat
disorder (arrhythmia), evaluation of measurement results of the device
can be given only after consultation with a physician.
CARE AND MAINTENANCE
To avoid the monitor attracting dirt, dust or other contaminants, wash and
dry your hands thoroughly before use.
Cleaning
• To clean the monitor exterior, wipe it with a cloth moistened with tap
water or a mild cleaning agent, then dry the device with a soft dry cloth.
Do NOT ush with water.
• Do NOT use organic solvents to clean the monitor.
• Do NOT wash the pressure cuff.
• Do NOT iron the pressure cuff.
Disinfection
If required (for example, in a hospital setting), disinfection of the pressure
cuff twice per week is recommended.
Disinfect the interior of the pressure cuff (the surfaces that come into
contact with the patient’s skin) with the use of a soft cloth soaked in ethyl
alcohol (75-90%) and wait for the pressure cuff to dry up.
Cleaning of the pressure cuff after 200 uses is recommended.
•
To Next Page
Loading...
