Gamma Control - Memory Function; Error Messages;Troubleshooting

55
EN
MEMORY FUNCTION
Automatic Blood Pressure Monitor Gamma
®
TM Control automatically
stores the result measured. To see the result of the last measurement
press and hold the ON/OFF button for at least 3 seconds. If an irregular
heartbeat interval was detected in the measurement stored in memory, the
icon
will be displayed.
TROUBLESHOOTING
lf you have trouble in using the unit please check the following points rst.
ERROR DISPLAY
POSSIBLE
CAUSE
HOW TO
CORRECT
Nothing is displayed.
When you push the
POWER button or
battery icon ash
No battery installation Insert batteries
Battery worn out
Replace with new
batteries
The polarities of
batteries placed
wrongly
Insert battery in the
correct polarities
E0
Testing pressure with
Clothes
Take off the clothes
and test it gain
The marker of arm cuff
is not in alignment
with the arm’s artery.
Align the marker of
arm cuff with the arm’s
artery, and measure
again.
E1: Can’t normally
increase pressure
Check your wrist cuff
for air leakage
Replace wrist cuff with
new one
E3: Inate pressure
too high
Remeasure or send
back to dealer to
recalibrate
E2 E4: Hand shak-
ing while measure-
ment
Hand or body shaking
while measurement
Keep static position
and
measure again
Battery icon on
Battery low power
Replace battery and
measure again