Gamma Smart - Using the Mains Adaptor; Cuff Connection Procedure

13
EN
• The batteries may leak and cause a malfunction.
• Use the specied batteries only. The batteries provided with the device
are for testing monitor performance and may have a shorter life.
0$#.Z(To prolong the batteries’ life the device switches off automatically
if no button is pressed for 1 minute. Otherwise you can switch it off by
pressing the START button.
"FPSQ(2S(%2PSF(!I2XEHJ
It is possible to operate Automatic Blood Pressure Monitor Model SMART
with a mains adaptor (output 6 V DC/ 500 mA).
1. Connect the micro plug to the socket at the device right side.
2. Plug the mains adapter (output 6 V DC/ 500 mA) to a 100-240 V
electrical power socket.
0$#.Z
• Please use the adaptor of Trademark 12332
4
. Any other adaptor being
used, the service center is not considered responsible for the warranty
servicing/repair of the monitor.
• No power is taken from the batteries while the mains adaptor is con-
nected to the device.
• Please consult service center if you have questions relating to the mains
adaptor.
'LTT(RHSSKREPHS
Insert the cuff connector into the opening provided on the side of the
device as shown in the picture.
SE
T
H/
M
M
/
D
ME
M.