RTxxx LEDlighting controllers - User Manual
If your light is voltage rated, use the p and q
buttons to select
Uol
and press the
SEL
button.
For current rated lights, use the p and q but-
tons toset the rating in Amps, and press the
SEL
button.
Or...
For voltage rated lights use the p and q but-
tons toset the rating in volts, and press the
SELbutton.
The light's rating is set up and the RT200 is
ready to use.
9.3 Setting up continuous output
Press and hold SELfor one second , CH1 is displayed. Use the p and q
buttons to select the channel you want to set up, and follow the keystrokes
below:
The channel you want to set up is displayed.
Press the
SEL
button.
— 32 —
RTxxx LEDlighting controllers - User Manual
Use the
p
and
q
buttons to select
SCo
and
press the
SEL
button.
bri
is displayed. Press the
SEL
button to select
the light's intensity.
Use the p and q buttons to set the intensity
from 1% to 99.9%. The default setting is 50%.
Press the SELbutton.
To set the error detection, press the
SEL
button
with
F E
displayed.
Or...
If you wish todisable the error detection, use
the
p
and
q
buttons to select
F-E
, and press
the
SEL
button.
Continuous output is set up on the RT200.
— 33 —
To Next Page
Loading...
