GARDASOFT RT Series - Setting Time Periods

RTxxx LEDlighting controllers - User Manual
trg
is displayed. Press the
SEL
button.
Use the p and q buttons to select the trigger
(
IP1
or
IP2
) you want to set up, and press the
SEL
button.
To set the trigger polarity so that it is active high,
press the
SEL
button with
F P
displayed.
Or...
If you wish toset the trigger polarity so that it is
active low, use the p and q buttons to select
F-P
and press the
SEL
button.
To set the error detection, press the
SEL
button
with
F E
displayed.
Or...
— 40 —
RTxxx LEDlighting controllers - User Manual
If you wish todisable the error detection, use
the
p
and
q
buttons to select
F-E
, and press
the
SEL
button.
Pulsed operation is set up on the RT200.
9.7 Setting time periods
When the RT200 requires you to enter a numeric value, the right hand digit
flashes to indicate you can use the p and q buttons to change the value.
To set pulse delay, retrigger, and pulse width values a scheme is used
where the exponent (power of 10) of the value is set. The exponent values
are as follows:
Exponent
value
Multiplier
Number
format
Range of values
E-2 0.01 9.99
Values are displayed in
seconds from 10ms to 5s in
steps of 10ms.
E-3 0.001 999.
Values are displayed in
milliseconds from 1ms to
999ms in steps of 1ms.
E-4 0.0001 99.9
Values are displayed in
milliseconds from 0.1ms to
99.9ms in steps of 0.1ms.
E-5 0.00001 9.99
Values are displayed in
milliseconds from 0.01ms to
9.99ms in steps of 0.01ms.
E-6 0.000001 999.
Values are displayed in
microseconds from 1μs to
999μs in steps of 1μs.
Note: The permitted range of values for pulse delay, pulse width, and
retrigger time is given in Section 13, Reference information, or as limited
by the operating conditions of the light.
— 41 —
WWW.STEMMER-IMAGING.COM