GARDASOFT RT Series - Page 40

RTxxx LEDlighting controllers - User Manual
trg
is displayed. Press the
SEL
button.
Use the p and q buttons to select the trigger
(
IP1
or
IP2
) you want to set up, and press the
SEL
button.
To set the trigger polarity so that it is active high,
press the
SEL
button with
F P
displayed.
Or...
If you wish toset the trigger polarity so that it is
active low, use the p and q buttons to select
F-P
and press the
SEL
button.
To set the error detection, press the
SEL
button
with
F E
displayed.
Or...
— 40 —
WWW.STEMMER-IMAGING.COM