GARDASOFT RT Series - 1 Getting Started; Summary of Features

RTxxx LEDcontrollers -User Manual
9.10 Viewing the trigger status
47
9.11 Viewing the output current
47
10 Ethernet communication(RT220, RT420, RT820F) 49
10.1 Connection
49
10.2 IP Address
49
10.2.1 DHCP 50
10.2.2 Fixed IP address 50
10.3 Automatic sensing
50
11 Webpage configuration (RT220, RT420, RT820F) 52
11.1 Main page
52
11.2 Configuration page
53
11.3 General setup page
54
12 Command configuration 55
12.1 Ethernet configuration(RT220, RT420, RT820F)
55
12.2 RS232 configuration(RT260, RT460, RT860F)
55
12.3 Command structure
55
12.3.1 General commands 56
12.3.2 Lighting channel commands 59
12.3.3 Command summary 61
13 Reference information 62
13.1 Specification
62
13.2 Restrictions
63
13.3 Error codes
64
13.4 Fatal error codes
65
13.5 Event codes
65
RTxxx LEDlighting controllers - User Manual
1 Getting started
This user manual describes the settingup and operation of the RTxxx
range of LED lighting controllers.
Read Section Safety (or Section 3, Sicherheit, or Section 4, Sécurité) and
Section 13.1, Specification, and check the RTxx controller fulfils your
requirements.
Mount the RTxxx as described in Section 5, Mounting the RTxxx and
connect the RTxxx up to a power supply as described in Section 6,
Connections. The RT200 shows a two alternating lines on it's display to
indicate it is working properly.
Read Section 8, Lighting setup. Enter the current or voltage rating of the
lights and then connect the lights. Set up the RTxxx for the desired
operation as described in the configuration sections; Section 9, Front
panel configuration (RT200), Section 11, Webpage configuration (RT220,
RT420, RT820F), and Section 12, Command configuration.
Visit www.gardasoft.com
for application notes on this product. There is
also a Support page which has information on troubleshooting problems.
1.1 Summary of features
Throughout this manual, references to the RTxxx refer to all variants in the
RTxxx range unless otherwise stated. The convention for the product
number is:
RTcd0-vv
RTcd0F-vv
where:
c
Number of channels: 2, 4, 8
d
Configuration option: 0 = Pushbutton, 2 = Ethernet,
6 = RS232
F
Option for fast pulsing. All RT8xx models are fast
pulsing.
vv
Maximum pulse current in amps: 2, 20
— 5 —
WWW.STEMMER-IMAGING.COM