GARDASOFT RT Series - Setting the Internal Trigger Timer

RTxxx LEDlighting controllers - User Manual
Use the p and q buttons to select
the required value in steps of 0.1ms.
Press the
SEL
button.
E-5
is displayed. Press the
SEL
button to enter time values from
0.01ms to 9.99ms.
Use the p and q buttons to select
the required value in steps of 0.01ms.
Press the
SEL
button.
E-6
is displayed. Press the
SEL
button to enter time values from 1μs
to 999μs.
Use the p and q buttons to select
the required value in steps of 1μs.
Press the
SEL
button.
9.8 Setting the internal trigger timer
You can set an internal trigger timer when the RT200 is in pulse mode.
When set, the RT200 triggers with the same delay and pulse width already
set up, as described in Section 9.6, Setting up pulsed operation. External
triggering remains unchanged.
— 43 —
RTxxx LEDlighting controllers - User Manual
Follow the keystrokesbelow toenter numerical data into the RT200 using
the above scheme:
E-2
is displayed. Press the
SEL
button to enter time values from
10ms to 5s.
Use the p and q buttons to select
the required value in steps of 10ms.
Press the
SEL
button.
E-3
is displayed. Press the
SEL
button to enter time values from 1ms
to 999ms.
Use the p and q buttons to select
the required value in steps of 1ms.
Press the
SEL
button.
E-4
is displayed. Press the
SEL
button to enter time values from
0.1ms to 99.9ms.
— 42 —
WWW.STEMMER-IMAGING.COM