RTxxx LEDlighting controllers - User Manual
If your light is voltage rated, use the p and q
buttons to select
Uol
and press the
SEL
button.
For current rated lights, use the p and q but-
tons toset the rating in Amps, and press the
SEL
button.
Or...
For voltage rated lights use the p and q but-
tons toset the rating in volts, and press the
SELbutton.
The light's rating is set up and the RT200 is
ready to use.
9.3 Setting up continuous output
Press and hold SELfor one second , CH1 is displayed. Use the p and q
buttons to select the channel you want to set up, and follow the keystrokes
below:
The channel you want to set up is displayed.
Press the
SEL
button.
— 32 —
To Next Page
Loading...
