GARDASOFT RT Series - Page 37

RTxxx LEDlighting controllers - User Manual
9.5 Setting up selected output
Set up selected output if you want to switch between to lighting levels on a
trigger input. Press and hold SELfor one second ,
CH1 is displayed. Use
the p and q buttons to select the channel you want to set up, and follow
the keystrokesbelow:
The channel you want to set up is displayed.
Press the
SEL
button.
Use the
p
and
q
buttons to select
SSE
and
press the
SEL
button.
b1
is displayed. Press the
SEL
button to set the
first intensity level.
Use the p and q buttons to set the first intens-
ity level from 1% to 99.9%. The default setting is
50%.
Press the SELbutton.
b2
is displayed. Press the
SEL
button to set the
second intensity level.
— 36 —
RTxxx LEDlighting controllers - User Manual
Use the p and q buttons to set the second
intensity level from 1% to 99.9%. The default
settingis 50%.
Press the SELbutton.
trg
is displayed. Press the
SEL
button.
Use the p and q buttons to select the trigger
(
IP1
or
IP2
) you want to set up, and press the
SEL
button.
To set the trigger polarity so that it is active high,
press the
SEL
button with
F P
displayed.
Or...
If you wish toset the trigger polarity so that it is
active low, use the p and q buttons to select
F-P
and press the
SEL
button.
— 37 —
WWW.STEMMER-IMAGING.COM