GARDASOFT RT Series - Page 53

RTxxx LEDlighting controllers - User Manual
11.2 Configuration page
There is one configuration page for each output channel, as shown below:
You can set up all the parameters for each output channel. Pressing the
Submit button updates the RTxxx configuration and saves the changes to
non-volatile memory. On this page you can:
Change the current rating for the light.
View some measured voltages and the actual output current.
Set the output mode: continuous, pulsed, or switched.
Set the pulse parameters.
— 53 —
RTxxx LEDlighting controllers - User Manual
11.2 Configuration page
There is one configuration page for each output channel, as shown below:
You can set up all the parameters for each output channel. Pressing the
Submit button updates the RTxxx configuration and saves the changes to
non-volatile memory. On this page you can:
Change the current rating for the light.
View some measured voltages and the actual output current.
Set the output mode: continuous, pulsed, or switched.
Set the pulse parameters.
— 53 —
WWW.STEMMER-IMAGING.COM