On the screen display, you will see an information screen that
shows how many images have been taken, the battery level,
camera or video mode, etc.
ATTENTION PLEASE: In the ON mode, the camera will
automatically enter SURVEILLANCE mode if there is no
operation (key pressing) within 5 minutes. Then the camera
will perform as your settings in the menu.
In the ON mode, you can connect the camera to a computer's
USB port to download your images.
7.3. SURVEILLANCE Mode
Any time after the batteries and SD card have been inserted,
you can switch on the camera. When the START button is
pressed, the camera will enter into the SURVEILLANCE
mode. If the Mode in the settings is set as "Motion Detection",
the camera will count down a 30-second delay and then be
ready to capture images. If the Mode is set as "Time Lapse",
there will be no 30-second counting down, and the camera will
be ready to enter Time Lapse.
Once in the SURVEILLANCE mode, no manual controls are
needed or possible (the control keys have no effect). The
camera will take photos or videos automatically (according to
its current parameter settings).
TIP: You can press the START button again to wake up the
camera and reprogram your camera if required.
To Next Page
Loading...
