What to do if my Garland ST284 Cookers oven pilot keeps going out?
Several issues could cause the pilot to go out. It could be a faulty thermocouple (check millivolt output), a faulty flame safety device (replace it), the pilot flame might be too small (check pilot flame length), or the thermocouple connection could be loose (check the connection).
Why does the burner flame shut off when my Garland ST284 Cookers oven is at the required temperature?
This issue can occur if the thermostat has an incorrect by pass rate. The solution is to replace the thermostat.
What causes delayed ignition in Garland ST284?
Delayed ignition can occur due to a few reasons: the pilot flame being too small (clean burner), burner ignition ports being blocked (check aeration shutter setting), or incorrect aeration (check millivolt output).
How to fix a Garland ST284 door that will not stay closed?
If the door won't stay closed, it could be due to insufficient tension on the springs (adjust the tension), a broken spring (replace it), or a broken hinge link (replace it).
Why is the millivolt output low on open circuit on my Garland Cookers?
A low millivolt output on an open circuit can be caused by the pilot flame being too small (adjust pilot flame length) or a defective thermocouple (replace it).
What to do if my Garland ST284 Cookers door is not level or low in the center?
If the door is not level, check the trunnion support. If it's loose, level and tighten it. If it's worn, replace it.
Why is the burner flame too large on my Garland Cookers?
If the burner flame is too large, it could be due to an incorrect setting pressure or injector. Check the setting pressure or injector.
What causes a noisy motor in Garland ST284 Cookers?
A noisy motor can be caused by the blower wheel rubbing on the oven baffle (adjust the blower wheel), the blower wheel being loose on the motor shaft (retighten the blower wheel), or a defective motor (replace the motor).
What to do if the flame safety valve will not stay open on my Garland ST284?
If the flame safety valve won't stay open, it's likely due to a faulty flame safety device. Replace the flame safety device.
What to do if my Garland ST284 Cookers cook/cool down switch is set to “Cook” position, the light is on, but the motor is not working?
If the switch is set to 'Cook', the light is on, but the motor isn't working, it could be several things: a defective Cook/Cool Down Switch (replace it), a defective door switch (replace it), faulty wiring (check conditions of wires and all connections), a defective motor (replace the motor), the oven door being open (close the door), or the door switch being out of alignment (align the door switch).
Warning against storing flammable liquids near the appliance.
Caution against improper installation, adjustment, alteration, service, or maintenance.
Instruction to consult local gas supplier for gas leak procedures.
Notice regarding chemicals known to cause cancer or reproductive harm.
Instruction to keep the appliance area clear of combustible materials.
Covers gas type, pressure checks, and connections.
Covers operation of open top burners, hot tops, and griddles.
Details on lighting, startup, cooldown, and shutdown for standard ovens.
Covers operation, motor care, and suggestions for convection ovens.
Covers pilot flame adjustment for various burner types and series.
Procedure for adjusting air shutters for optimal burner flame quality.
Details on the FDO thermostat and its by-pass flame adjustment.
Instructions for adjusting and recalibrating the BJWA griddle thermostat.
Lists common oven problems like temperature issues and pilot outages.
Problems related to open burners with and without flame supervision devices.
Lists common fryer problems like low millivolt output and ignition failures.
To Next Page
General
