Garmin GLO 2 - Pairing the Sensor; Acquiring Satellite Signals

3
Pairing the Sensor
1
Hold to turn on the sensor�
2
Turn on the other device and enable
the Bluetooth component�
You can refer to the device’s
documentation for specic instructions
about enabling Bluetooth wireless
technology�
3
Bring the sensor within 30 feet (10
meters) of the mobile device�
4
Using the mobile device, pair the
sensor with the mobile device�
The blue LED is solid blue when the
sensor is connected to the other device�
If the sensor has not established a
Bluetooth connection for several minutes,
it turns off automatically�
Bluetooth LED
LED Description
Slow ashing
blue
Searching for mobile devices
Rapid ashing
blue
Pairing
Solid blue Connected to mobile device
Status LED
LED Description
Slow ashing orange Charging
Solid orange Battery charged,
power connected�
Orange off Battery charged,
power disconnected�
Rapid ashing orange Low battery
Alternating orange
and green
Faulty battery or
system error
Flashing green Searching for GPS
satellites
Solid green GPS satellite x
Acquiring Satellite Signals
1
Verify that the blue LED on the sensor
is solid blue, indicating a wireless
connection�
2
Place the sensor where it has a clear
view of the sky�
Acquiring satellite signals may take a
few minutes. The Status LED ashes
green while searching for satellites and
establishing your location� The Status LED
is solid green when it has established a x
on your location�
Glo_2_Instructions_print.indd 3 8/1/2018 12:36:52 PM