Mounting Your 2720
1. Align the power plug on the vehicle adapter to the connector and slide
the plug into the connector until fully seated, as shown to the right.
2. Slide the locking lever on the mounting base to the left, in the
unlocked position.
3. Slide the bottom of the StreetPilot into the mounting base until it
clicks into place.
4. Slide the locking lever to the right.
5. Plug the power adapter into an available cigarette lighter receptacle
in your vehicle. Route the cable so it does not interfere with vehicle
operation.
6. Flip the power switch on the side of the StreetPilot down.
Following Your Route
Follow the route to your destination using the map. As you travel, your StreetPilot guides you to your destination with voice
prompts, arrows, and directions along the top of the map. If you depart from the original route, your StreetPilot recalculates
the route and provides new route instructions.
Read the driving
directions along the top
of the map.
Your route is marked with
a magenta line.
Follow the arrows. A checkered flag marks
your destination.
Finding Your Destination
➊
Touch Where To?
➐
Enjoy the route!
➋
Touch Food, Hotel….
➌
Touch Food & Drink.
➍
Touch a food category.
➎
Touch the place.
➏
Touch Go To.
StreetPilot
®
2720
quick reference guide
Warning: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the 2720 installed to place and secure the device so it will not interfere with the vehicle
operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an accident.
Locking lever Release tab
To Next Page
Need help?
General
