Page 2
Factory Voltage
Each PD-5 comes with the above insert identifying the factory set voltage configuration. If the identified voltage
does not match your voltage mains, the correct voltage can be easily configured using the field selectable switch.
In the event the PD-5’s voltage setting needs to be changed, please perform the following steps:
NOTE: BEFORE PERFORMING ANY MAINTENANCE ON THE PD-5, TURN THE UNIT OFF
AND UNPLUG THE POWER CORD FR
OM THE ELECTRICAL OUTLET.
1) Remove 11 screws with T-20 Torx Driver from the chassis’ right side.
To Next Page
Loading...
