INFORMATION
Notes
Cautions
Incorrect installation and testing of the TWIN could
potentially damage either the vehicle’s battery and/or the
TWIN itself.
Poor quality electricity may harm the TWIN and or
the vehicle. An example of such source of poor quality
electricity may be private power generators.
Do not operate the TWIN in temperatures outside its
operating range – see technical specifications.
Some energy meters have touch protection covers
over the terminals that must be installed during use
of TWIN to have valid guarantee
All installation must be carried out by an authorised
installer and comply with local installation regulations.
If any questions, please contact your local electrical
authority.
Ensure that the TWIN’s charging cable is positioned
so it will not be stepped on, driven over, tripped on, or
subjected to damage or stress.
Unroll the charging cable to prevent it from overheating.
Do not use cleaning solvents to clean any of the TWIN’s
components. The outside of the TWIN, the charging
cable, and the end of the charging cable should be
periodically wiped with a clean, dry cloth to remove
accumulation of dirt and dust.
Be careful not to damage the circuit boards or
components during installation.
Refer to local standards and regulations not to exceed
charging current limitations.
The front cover must always be locked in order to ensure
compliance with IP Code IP44.
Avoid installing the TWIN in direct sunlight to avoid any
heat-problems.
To even out the load, it is important to rotate the phases
when connecting several of TWINs to the same supply.
Note that 1-phase charging is common in electric vehicles
and L1 and L2 in the TWIN is used for this purpose.
Ventilation signal from EV is not supported.
Adapters for charging connectors are not allowed to be
used.
Cord extension sets for charging cable is not allowed to
be used.
Electrical vehicles (EV) software and the TWIN firmware
are continuously updated.
To make sure that the TWIN is working properlty, it
is necessary to update the firmware and it requires a
communication card.
Communication cards are available as an accessory.
TWINs installed in a cluster only need the
master to have the communication card installed.
4
EN
To Next Page
Loading...
