4
Use a quick power off/
power on process to tune
out mineralized ground,
saltwater, wet sand, and other
challenging environments.
Lanyard Attachment Clip
Use to attach the Pro-Pointer II to your belt, digging pouch or your detector
(if desired).
Holster
Secure to any standard size belt. A metal snap within the holster will cause
the pinpointer to alarm if put away while powered on.
Low Battery Alarm
When the battery becomes low, the detector will sound an alternating dual-
tone alarm. Replace the 9V battery as soon as possible.
Retuning for Mineralized Ground or Wet Salt Sand
To tune out the detection of saltwater, wet sand or highly mineralized
ground, hold the tip of the Pro-Pointer II to the water, sand or soil and
quickly press the power button () off and back on again. If necessary,
repeat this retune process to further eliminate any environmental response.
5
Precisely Pinpointing Large Targets
When locating large metal objects—whether in the ground or in a
wall—you can improve the pinpointing capability by retuning the Pro-
Pointer II in order to narrow the detection field.
Slowly scan toward the object until the response increases to full/
constant alarm. Then, without moving the detector, quickly press the
power off and back on again in order to retune and narrow the detection
field. Continue scanning toward the object to find its precise location.
Repeat this quick retune to further narrow the detection field as needed.
Return the Pro-Pointer II to full detection strength by simply switching
the power off and back on while holding it away from metal.
Battery Replacement
Simply rotate the battery cover counterclockwise to remove and
clockwise to tighten by hand. To properly install the 9V battery, match
the larger battery terminal to the larger opening in the compartment.
Remove the battery when the unit is to be stored more than 30 days.
To Next Page
Loading...
Need help?
Operating Environment
Battery
Weight and Dimensions
