www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
43
support@gaslandchef.com
1 (844) 538-7890
Problem
The oven is
not clean after
a Self-clean
cycle.
The oven controls were not
set correctly.
See the section on Self-clean
on page 33.
Steam is
coming out of
the vent.
When using the convection
feature, it is normal to see
steam coming out of the
oven vent.
As the number of racks or
amount of food being cooked
increases, the amount of
visible steam will increase.
This is normal operation and
not a system failure.
Use the oven as usual.
A burning or
oily odor is
coming from
the vent.
This is normal for a new oven
and will disappear in time.
• To speed the process, set
a Self-clean cycle for a
minimum of 3 hours.
• See the section on Self-clean
on page 33.
Strong door.
An odor coming from the
insulation around the inside
of the oven is normal for the
first few times the oven is
used.
Operate the oven empty on
the bake setting at
400°F(204°C) for 1 hour.
The oven door
is locked.
The circuit breaker has been
tripped or there was a power
failure while the oven door
was locked.
Activate Control Lockout,
and then unlock the control.
See the Control Lockout
section on page 21.
The oven was heavily soiled.
Wipe up heavy spillovers
before starting the
Self-clean cycle. Heavily
soiled ovens may need to be
Self-cleaned again or for a
longer period of time.
Possible cause Solution
The oven door
will not open
after a
Self-clean
cycle.
The oven is too hot. Allow the oven to cool.
To Next Page
Loading...
