GASLAND chef Pro Series - Page 47

www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
support@gaslandchef.com
1 (844) 538-7890
46
Error
Code
Error Code
Description
Cause for the
Error Code
After Sales
Service
E4
The oven temperature
is too high even not
under Self-clean
function.
E5
E6
After preheating for 10
minutes. Oven
temperature without
change.
The electronic
components of the main
control circuit board are
broken.
Electric range only:
heating elements broken.
Electric range only: AC
240V powered off.
The thermal protector K2
or K3 is broken.
Replace the circuit
board.
When oven under
preheat, the tempera-
ture will no longerrise
after the previousrised.
The electronic
components of the circuit
board are broken.
Replace the circuit
board.
Electric range only:
heating elements broken.
Replace the
heating element.
The thermal protector K2
or K3 is broken.
Replace the
thermal protector
K2 or K3.
Possibly poor contact
between the wiring
terminal of the wire set
and the connector at the
CN7 position of the
circuit board.
Replace the
thermal protector
K2 or K3.
The oven door switch is
broken, causing the
circuit to misjudge that
the door is open, so the
oven stops heating.
Replace the oven
door switch.