Gasmate BQ1022 - General Assembly

5
4
GENERAL ASSEMBLY
Connecting & Disconnecting to
the gas source
Familiarise yourself with the general
information and safety guidelines located at the
front of this manual.
Check:
1. The cylinder is lled. A sloshing sound will be
heard when shaken.
2. The burner controls are in the ‘OFF’ position
Connecting:
1. Ensure cylinder valve is in its full off position.
2. Check for any damage to either the cylinder
connection or the hose. NEVER attempt to use
damaged equipment.
3. When connecting the hose to the cylinder
tighten the nut to a positive stop by hand
or spanner.
4. Open cylinder valve fully. If a leak can be heard
at either end of the hose turn cylinder off and
tighten joint. Wait 5 minutes before re-testing
and use a soapy water solution to check the
joint. If bubbles appear, the connection will
need to be re-tightened.
Disconnecting:
1. Ensure the burner control is in the
‘OFF’ position.
2. Ensure cylinder valve is in the full off position.
For storage and cylinder exchange, disconnect
hose at the cylinder only, DO NOT disconnect hose
from appliance.
ELECTRICAL DATA
IMPORTANT
This product is tted with a sealed electrical
connection plug that is compatible with the
product, the mains supply for New Zealand
and meets the requirements of international
standards. This product must be connected to a
supply voltage that is equal to that stated on the
rating label. If the mains connection plug or power
cord becomes damaged it must be replaced with a
complete assembly that is identical to the original,
and this must be replaced by an authorised
service centre. Always follow the New Zealand
requirements for connection to the mains supply.
If in doubt always consult a qualied electrician.
Technical Specication
YeeFu Electronic Enterprises
Model No YOSAA12002000A
Voltage Input 220-240V AC 50Hz
Voltage Output 12V - 2000mA