6
LIGHTING PROCEDURE
Burner Operation & Ignition System Check
1. Turn the control knobs clockwise
to “OFF” position.
2. Connect the regulator to the gas bottle. Turn
the gas supply “ON” at the cylinder. Check
with the use of soapy water for any gas
leakage between the bottle and the regulator.
3. Push down a control knob and keep
pressing whilst turning anti-clockwise
to the “HIGH” position whilst also pressing the
ignition button (a clicking sound is heard), this
will light the burner. If the burner does not light,
repeat this process.
4. If the burner still does not light, turn the control
knob to ‘OFF’ wait 5 minutes and repeat step 3.
5. Adjust the heat by turning the knob to the High/
Low position.
6. To turn the barbecue ‘OFF’, turn the cylinder
valve to the ‘OFF’ position and then turn all of
the control knobs on the appliance clockwise to
the ‘OFF’ position.
If the rotisserie back burner fails to remain alight
or the ame pattern is disturbed, ensure it is not
facing into a direct wind. Re-position the direction
of the BBQ, wait 5 minutes, and try the lighting
procedure again.
Before cooking for the rst time, operate the
barbecue for about 15 minutes with the lid closed
and the gas turned on HIGH. This will “heat
clean” the internal parts.
Problem: Burner will not ignite
Possible Reason Solution
Valve on cylinder
is closed
Open valve on cylinder
Control knob is off Turn knob to high
when lighting
Igniter is faulty Use a long barbecue
match
Ignition system check
To Next Page
Loading...
