Gasmate GALAXY GEN2 - Electrical Information

54
IMPORTANT SAFEGUARDS
READ THESE INSTRUCTIONS CAREFULLY
BEFORE USING THE PRODUCT. KEEP
THE INSTRUCTIONS HANDY FOR FUTURE
REFERENCE.
Important: Always operate the Product from a
power source of the same Voltage, Frequency and
Rating as indicated on the Product Identication
Plate.
• DO NOT operate any product which has been
or appears damaged in any manner or after the
Product malfunctions, or is dropped.
• Always arrange the Cord so that it cannot be
pulled or tripped over.
• DO NOT operate this Product immediately below
an electrical Socket Outlet.
• Avoid operating the Product on uneven surfaces.
Use only on at, level and stable surfaces.
• DO NOT disconnect the Product from the Power
Supply by pulling on the Cord. Never move,
carry or hang the Product by the Cord.
• DO NOT operate this Product in the presence of
explosive and/or ammable liquid or fumes
such as where aerosol (spray) Products are being
used or where Oxygen is being administered.
• Switch OFF and UNPLUG from Power Outlet
when not in use, allow to cool before shifting the
Product from one location to another, and before
cleaning.
• DO NOT use the product during inclement
weather, rain or damp conditions.
To reduce the risk of personal injury or damage
to property, follow basic safety precautions
when using this product, including the
following:
• DO NOT use the Product for other than its intended
use as described in these instructions. This Product
is intended for Normal Domestic Household Use only.
The use of accessory attachments other than those
recommended by the manufacturer may cause safety
hazards.
• The power supply must be supplied through a
residual device (RCD) having a tripping current not
exceeding 30mA.
• Only connect this product to a socket-outlet having
an earthing contact.
• DO NOT operate the product with a damaged cord
or plug, or if it malfunctions, or has been damaged in
any manner.
• Never operate this product when your are tired,
drinking alcohol, taking drugs or if taking medication
that causes drowsiness.
• This product is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision
or instruction concerning use of the product by a
person responsible for their safety.
• Pets and animals must be kept away from the work
area so as to avoid tripping dangers.
• Never modify this Product as damage and injury may
occur, and this will void your warranty.
• Check for damaged parts before operating this
Product.
• Keep power cord away from heat, oil, solvents and
sharp edges.
• Check power cord for signs of damage before each
use. If damaged do not use.
• Power cord must only be replaced by an authorised
service facility.
• Use only a ‘3’ core (earth pin) extension cord with this
Product.
NOTE: This transformer must only be used with the lights
in your BBQ.
ELECTRICAL INFORMATIONGENERAL INFORMATION
Gas Installation Codes
• Barbecues must be used in accordance with the
installation requirements of your gas supply authority,
or the Australian Standard AS 5601.
• Barbecues for use with bottled gas are labelled
‘propane gas’.
• Barbecues for use with natural gas are labelled
‘natural gas’ and must be installed by an authorised
person. Check the gas type sticker attached to the
barbecue.
Minimum clearance:
For non-combustible material: Rear - 20mm for
ventilation, and 145mm in total including hood rollover
clearance
For combustible material: Rear - 200mm, Sides - 200mm
Specications
Barbecue specications can be found on the data label
attached to the barbecue body.
Hose connection thread is 5/8”-18 UNF
IMPORTANT
Read these instruction carefully prior to use.
Familiarise yourself with the appliance before
connecting it to it’s gas container. Keep these
instructions for future reference.
IF YOU SMELL GAS
1. Shut off gas to the barbecue at its source,
if possible.
2. Extinguish any open ame.
3. Open hood.
4. If odour continues immediately call your gas
supplier or re department.
Hose & Regulator Safety
The regulator and hose assembly supplied with the
barbecue are suitable for Propane Gas.
A gas regulator adjusted to have an outlet pressure of
2.75kPa is supplied for connection to the propane gas
cylinder. The pressure regulator and hose assembly
supplied with the barbecue must be used. Replacement
pressure regulators and hose assemblies must be those
specied by the barbecue manufacturer.
When connecting the hose and regulator assembly to the
gas cylinder, take care to avoid unnecessary twisting of
the exible hose.
After the assembly has been secured, turn on the gas
and check for leaks by brushing a soap and water
solution over all connections.
If you are unable to correct the leak by tightening the
connections, turn off the gas and contact the supplier
immediately.
Always ensure the barbecue is kept away from ammable
materials and the gas cylinder clear of any heat source.
When changing over from an empty gas cylinder to a
full one make sure this procedure is carried out in a well
ventilated location, preferably outside, away from people
and away from any sources of ignition; such as naked
ames, pilot ames, electric heaters/equipment.
Gas Cylinder Use & Safety
This is a low pressure barbecue and must only be used
with the regulator supplied. Your barbecue is designed
for use with 4.5Kg or 9Kg propane gas cylinders certied
to AS 2469.
The gas cylinder should be lled by a reputable gas
supplier and visually inspected and re-qualied at each
lling.
Always keep cylinder in an upright position. Always close
the cylinder valve when the barbecue is not in use.
Do not subject gas cylinder to excessive heat.
NEVER STORE YOUR GAS CYLINDER
INDOORS.
If you store your barbecue indoors, ALWAYS disconnect
the gas cylinder rst and store the cylinder safely outside.
Cylinders must be stored outdoors in a well ventilated
area out of reach of children, and must not be stored in a
building, garage or any other enclosed area.
This appliance has been supplied with the new safer gas
cylinder connection Safe Lok LCC27 Type 27 regulator
and hose connection. This connection will only connect
to a 4kg or 9kg gas cylinder with an LCC27 Type 27
cylinder valve. This connection will NOT connect (screw)
to the old type 21 POL gas cylinder valve.