Gasmate RIO BBQ - Table of Contents

2
3
Gas Installation Codes
•Appliancesmustbeusedinaccordancewiththe
 installationrequirementsofyourgassupply
 authority,ortheAustralianStandard
 AS/NZS5601.
•Appliancesforusewithbottledgasarelabelled
 ‘propanegas’.
Clearances
MinimumClearancesfromcombustiblematerials
mustbe:
Rear-300mmSides-300mmAbove-300mm
Hose & Regulator Safety
Theregulatorandhoseassemblysuppliedwiththe
appliancearesuitableforpropanegasonly.
Agasregulatoradjustedtohaveanoutlet
pressureof2.75kPAissuppliedforconnectionto
thepropanegascylinder.Thepressureregulator
andhoseassemblysuppliedwiththeappliance
mustbeused.Replacementpressureregulators
andhoseassembliesmustbethosespeciedby
theappliancemanufacturer.
Whenconnectingthehoseandregulatorassembly
tothegascylinder,takecaretoavoidunnecessary
twistingorkinkingoftheexiblehose.
Aftertheassemblyhasbeensecured,turnonthe
gasandcheckforleaksbybrushingasoapand
watersolutionoverallconnections.
Ifyouareunabletocorrecttheleakbytightening
theconnections,turnoffthegasandcontactthe
supplierimmediately.
Alwaysensuretheapplianceiskeptawayfrom
ammablematerialsandthegascylinderclear
ofanyheatsource.Whenchangingoverfrom
anemptygascylindertoafullonemakesure
thisprocedureiscarriedoutinaamefree
atmosphere.
Specications
Specicationscanbefoundonthedatalabel
attachedtothebody.Hoseconnectionthreadis
5/8-18”UNF.
GENERAL INFORMATION
Section Page
Generalinformation 3
Warnings 4
Assemblyandlightingprocedure 5
Operatingprocedure 6
Careandmaintenance 7
BBQcomponentsandassembly 8
Safelocations 10
Warranty 11
CONTENTS