Gasmate RIO BBQ - Assembly and Lighting Procedure

4
5
GENERAL ASSEMBLY
Connecting & Disconnecting to
the gas source
Check:
1.Thecylinderislled.Asloshingsoundwillbe
 heardwhenshaken.
2.Theburnercontrolisinthe‘OFF’position.
Connecting:
1.Ensurecylindervalveisinitsfulloffposition.
2.Checkforanydamagetoeitherthecylinder
 connectionorthehose.NEVERattempttouse
 damagedequipment.
3.Ensureburnercontrolisinthe‘OFF’position.
4.Whenconnectingthehosetothecylinder
 tightenthenuttoapositivestopbyhand
 orspannerdependingonthetypeoftting.
5.Opencylindervalveandleaktestall 
 connectionswithasoapywatersolution.
 Ifaleakisfound,turncylindervalveoffand
 retightentheconnection.
Disconnecting:
1.Ensuretheburnercontrolisinthe‘OFF’
 position.
2.Ensuregascylindervalveisinthefulloff
 position.
3.Forstorageandcylinderexchange,disconnect
 hoseatthecylinderonly.DONOTdisconnect
 hosefromappliance.
Problem Possible Reason Solution
Burner will not ignite Valveoncylinderisclosed Openvalveoncylinder
Controlknobisclosed Turnknobtohighwhenlighting
Ignitorisfaulty Usealongbarbecuematch
Food is not cooking or
is taking too long
Burnerhasgoneout Checkthatthegasbottleisnot
emptyandre-ignitetheburner
Cookingsurfacewasnotgiven
enoughtimetowarmupbefore
thefoodwasapplied
Removethefoodandgivethe
burnertimetowarmthecooking
surface(5-10minutes)
Thereistoomuchfoodonthe
cookingsurface
Cooksmallerportions
Burner operation
LIGHTING PROCEDURE
Burner Operation &
Ignition System Check
1.Withcylindervalvein‘OFF’positionpushand
 turncontrolknobanti-clockwiseuntilthecontrol
 knobclicks.Repeatactionandcheckfor
 sparkingattheburner.
2.Ifsparkisnotevidentattheburnerignition
 point,checkthattheignitionleadisrmly
 attachedtothecontrolandsparkertip.
3.Withsparkingestablishedturnthecylinder
 valve‘ON’.Thehoodmustalwaysbeinthe
 openpositionforlighting.Pushandturnthe
 controlknobanti-clockwiseto‘HIGH’.
4.Iftheburnerfailstolightafterseveralattempts
 turnoffgassupplyatcylinderandinspectfor
 obstructionstogasow.
Ifre-ignitionisnecessarywhiletheapplianceis
stillhot,youmustwaitforaminimumof
5minutesbeforecommencingtore-ignite
(thisallowsaccumulatedgasfumestoclear).