www.gateway.com
7
Replacing a bay module
Tools you need to complete this task:
Screws removed during this task:
To replace a bay module:
1 If you are removing a drive, make sure that there is no disc in it.
2 Complete the steps in “Preparing the convertible notebook” on page 5.
3 Turn the convertible notebook over so the bottom is facing up.
Phillips #0 screwdriver
1 black 2.5*8.0 (Optional
bay module security
screw)
Modular bay latch
Modular bay
Security screw (optional)
To Next Page
Loading...
