Replacing convertible notebook components
26
Replacing the hinge covers
Tools you need to complete this task:
v
To replace the hinge covers:
1 Complete the steps in “Preparing the convertible notebook” on page 5.
2 Turn the convertible notebook over so the top is facing up.
3 Insert the small flat-blade screwdriver or non-marring tool under the bottom of the back
hinge cover, then carefully pry it up.
4 Open the LCD panel to the fully open position, insert the small flat-blade screwdriver or
non-marring tool under the bottom of the front hinge cover, then carefully pry it up.
5 Snap the new front cover into place over the hinge, then snap the back cover into place.
Flat-blade driver Scribe or non-marring tool- OR -
To Next Page
Loading...
