Setting up the monitor
3
Setting up the monitor
Setting up the monitor consists of two procedures: attaching the base and connecting the
monitor cables.
If you are setting up your system for the first time, refer to the setup poster for more
information about connecting additional peripherals.
To attach the base:
1
Carefully set the monitor on its side with the bottom of the monitor facing you.
2
Hold the base so that the narrow end is pointed toward the back of the monitor.
3
Align the four hooks on the bottom of the base with the corresponding slots on the
bottom of the monitor.
4
Slide the base toward the front of the monitor so that all hooks are securely in place.
A retaining latch built into the base clicks into place when the base is correctly
attached.
5
Carefully set the monitor upright and place the monitor on a sturdy, level surface.
To Next Page
Loading...
Need help?
General
