Adding or replacing memory modules
www.gateway.com
9
To add or replace memory modules:
1 Complete the steps in “Preparing the notebook” on page 5.
Tips & Tricks
The screw hole is marked with a K.
2 Remove the keyboard screw.
3 Loosen the six memory bay cover screws (these screws cannot be
removed).
4 Use the thumb notch to lift the memory bay cover, then remove it. Be
careful not to break off the tabs located on the end of the cover opposite
of the thumb notch.
Screw
Screws
To Next Page
Loading...
Need help?
General
