Replacing Gateway Notebook Components www.gateway.com
26
Replacing the keyboard cover
Tools you need to complete this task:
Screws removed during this task:
To replace the keyboard cover:
1 Complete the steps in “Preparing the notebook” on page 5.
2 Turn the notebook over so the top is facing up.
3 Remove the two keyboard cover screws.
4 Insert the small flat-blade screwdriver or non-marring tool under the
bottom each LCD panel hinge and gently pry it up.
5 Carefully open the LCD panel to the fully opened position.
Flat-blade driver Scribe or non-marring tool- OR -
Phillips #0 screwdriver
2 black (keyboard cover)
Screw
Screw
To Next Page
Loading...
Need help?
General
