GE Security FireShield FS1004 - FSDACT Programming Worksheet

Programming templates
B.2 FireShield Technical Reference Manual
FSDACT programming worksheet
DACT setup
Access passcode (0 – 9, A – F) 1111111
Load defaults  Yes  No
Edit passcode (0 – 9, A – F)
Date (MMDDYYYY) 01012002
Time (HHMM) 0000
DACT mode  Single line DACT  Dual line DACT  Modem/LCD  LCD only
Receiver 1 (DACR1) Setup
Phone 1 Ex. 19415551212
Phone 2 Ex. 19415551212
Account (0 – 9, A – F) FFFF
Format  Contact ID  EST 4/2
Restores  Send Restores  No Restores
Retry Count (05 – 10) 05
Retry Time (05 – 10) 05
Receiver 2 (DACR2) Setup
Phone 1 Ex. 19415551212
Phone 2 Ex. 19415551212
Account (0 – 9, A – F) FFFF
Format  Contact ID  EST 4/2
Restores  Send Restores  No Restores
Retry Count (05 – 10) 05
Retry Time (05 – 10) 05
DACT Dialing Properties Setup
Tone/Pulse Line 1  Tone  Pulse
Tone/Pulse Line 2  Tone  Pulse
AC Fail Delay  6 Hours  15 Hours
Transmission Test Time (0000 – 2359) 0217
Transmission Test Freq. (00 – 02) 01
Rings to Answer (00 – 15) 05
Ring Type  Ring type DACT answers any ring type after programmed ring count
Callback Enable  No  Yes
Callback Number
Note: Default settings are shown in boldface type.