40
PETER CHAN
EXIT
EDIT
317 - 123 - 4567
DEL
0 3
MEMO
#
6. Press the redial button to display the redial number.
7. P ress the OK soft key again to confirm.
NOTE: If the redial number has more than an 24 digits, the redial number
cannot be stored in memory.
INSERTING A PAUSE IN THE DIALING SEQUENCE
If a pause is needed to wait for a dial tone press the # pause button on
the touch-tone pad to insert a delay in dialing sequence of a stored
telephone number (for example, after you dial 9 for an outside line, or
wait for a computer access tone.) Each pause counts as one digit in the
dialing sequence.
REVIEWING, CHANGING OR DELETING STORED NUMBERS
TO REVIEW:
1. Make sure the phone is OFF (not in TALK mode).
2. Press DIR soft key.
3. Press the cid/vol ( or ) button on the handset or CID/messages ( or )
button on the base to scroll through the stored numbers. Or use the touch-
tone pad on your handset or base to enter the memory location number.
TO CHANGE:
Use the same procedure to change a stored number as you do to store a
number except replace one stored phone number with a different one.
HANDSET 1
DIR
MENU
NAME
ANS
To Next Page
Loading...
