GE 869 - 5 Dnp; Iec104 Point Lists

869 MOTOR PROTECTION SYSTEM – COMMUNICATIONS GUIDE 5-1
869 Motor Protection System
Chapter 5: DNP / IEC104 Point Lists
GE
Digital Energy
DNP / IEC104 Point Lists
The menu for the DNP/IEC104 point lists is shown below.
Path: Setpoints > Device > Communications > DNP/IEC104 Point Lists
The binary inputs points for the DNP protocol, or the MSP points for IEC 60870-5-104
protocol, can be configured to a maximum of 96 points. The data source for each point is
user-programmable and can be configured by assigning FlexLogic operands.
The menu for the binary input points (DNP) or MSP points (IEC 60870-5-104) is shown
below.
Path: Setpoints > Device > Communications > DNP/IEC104 Point Lists > Binary Input/MSP
Points
Up to 32 analog input points can be configured for the DNP or IEC 60870-5-104 protocols.
The menu for the analog input point (DNP) or MME points (IEC 60870-5-104) is shown
below.
Message
Message
DNP / IEC104
POINT LISTS
Range: se e sub-menu below
n BINARY INPUT / MSP
n POINTS
n ANALOG INPUT / MME
n POINTS
n BINARY OUTPUT /
n CSC/CDC POINTS
Range: se e sub-menu below
Range: se
e sub-menu below
Message
Message
Range: FlexLogic op
Default: Off
erand
n BINARY INPUT / MSP
n POINTS
Point 0 Entry
Range: FlexLogic op
Default: Off
erand
Range: FlexLogic op
Default: Off
erand
Point 1 Entry
Point 95 Entry