Why does my GE ADEL20 Dehumidifier run too much?
If your GE Dehumidifier runs excessively, consider these factors: the area you're trying to dehumidify might be too large for the unit's capacity. Additionally, open doors and windows will cause the dehumidifier to work harder. Ensure all doors and windows are closed to the outside.
Why does frost appear on the coils of my GE Dehumidifier?
The appearance of frost on the coils of your GE Dehumidifier is normal if the unit has been recently turned on or if the room temperature is below 41°F (5°C). The frost should disappear within 60 minutes. Refer to the Automatic Defrost section for more information.
Why can't I set the control on my GE ADEL20 Dehumidifier?
It's normal for the compressor to turn off while the fan continues to run automatically for about 3 minutes at a fixed setting. Wait approximately 3 minutes before setting the fan as desired.
Why does my GE ADEL20 Dehumidifier not dry the air?
Several factors can prevent your GE Dehumidifier from effectively drying the air. First, it may simply need more time, especially after initial setup—allow at least 24 hours to reach the desired dryness. Check for obstructions like curtains or furniture blocking airflow to the unit. Ensure the filter is clean, following the Care and Cleaning section instructions. The humidity control might be set too high; lower it for drier air, setting it to 16 for maximum dehumidification. Also, ensure doors and windows are tightly closed, and the dehumidifier isn't near a clothes dryer venting moisture into the room. Finally, remember that moisture removal is most effective at higher room temperatures.
What to do if my GE ADEL20 Dehumidifier does not start?
If your GE Dehumidifier isn't starting, there are several potential reasons: * **Check the power:** Ensure the dehumidifier is fully plugged into the outlet. * **Examine the fuse/circuit breaker:** Inspect your house's fuse or circuit breaker box, replacing the fuse or resetting the breaker if necessary. * **Verify the settings:** The dehumidifier may have reached its preset level or the bucket might be full. Adjust to a lower setting or empty and replace the bucket correctly. * **Position the bucket properly:** The dehumidifier will only operate if the bucket is correctly placed and securely seated. * **Consider power failure delays:** After a power outage, there's a protective 3-minute delay to prevent compressor overload, so the unit may not immediately restart.
Why is the Bucket Full LED light flashing and alarm sounding on my GE Dehumidifier when the drain hose is connected?
If the 'Bucket Full' LED is flashing and the alarm is sounding on your GE Dehumidifier while the drain hose is connected, it could be due to a loose drain hose connection. Check the drain hose connection to ensure it is tight on the fitting. Another possibility is that the drain hose is kinked. Make sure the drain hose points straight down to the floor without any kinks.
Why is there water on the floor near my GE Dehumidifier?
If you find water on the floor near your GE Dehumidifier, it could be due to a loose hose connection. Check the hose connection to ensure it is secure. Also, if you're using a bucket to collect water but have a hose attached, disconnect the hose.
Why is my GE Dehumidifier making fan noise?
The fan noise you hear from your GE Dehumidifier is normal, as it is simply the sound of air moving through the unit.
Discusses risks associated with extension cords for dehumidifiers.
Details proper grounding and outlet connection for safe operation.
Provides information on how to recycle the appliance.
Explains the function of each button on the dehumidifier's control panel.
Details operational aspects like empty light, alarm, auto shut off, and auto defrost.
Provides initial setup guidance and operational tips for the dehumidifier.
Explains the internal process of drawing in moist air and releasing dry air.
Describes how the unit manages frost buildup on evaporator coils.
Offers guidance on optimal placement for effective dehumidifier operation.
Details methods for emptying collected water using the bucket or a hose.
Explains automatic shut-off when the bucket is full or removed.
Instructions for cleaning the exterior surfaces of the dehumidifier.
Guidance on how to clean the water collection bucket to prevent mold.
Instructions for removing, cleaning, and replacing the air filter.
Addresses common causes and solutions when the unit fails to power on.
Solutions for issues related to the dehumidifier not removing moisture effectively.
Troubleshooting steps for when the dehumidifier runs too much.
Explains normal frost behavior and how to resolve control setting problems.
Details the one-year limited warranty for replacement, repair, or refund.
Provides instructions for submitting a claim within the first 90 days and remainder of the year.
Lists exclusions from warranty coverage, such as installation or misuse.
Information on accessing support, product information, and services online.
Encourages online registration for enhanced communication and warranty service.
Details on how to schedule expert repair service online or by phone.
Information on purchasing extended warranties and available discounts.
Guidance on ordering replacement parts and accessories for the appliance.
Provides contact information for customer relations if unsatisfied with service.
General| Energy Star Rated | Yes |
|---|---|
| Continuous Drain Option | Yes |
| Humidity Control | Adjustable Humidistat |
| Auto Shut-off | Yes |
| Capacity | 20 pints |
| Filter Type | Washable |
To Next Page
