PREPARATION
[EN] English 33 K0553 Revision D
4) Make sure the air vents do not become obstructed.
5) Connect the required hoses to the ADTS that are necessary for the test procedures to be
carried out.
6) Fit the necessary adaptors for aircraft testing to the hoses.
NOTE: When connected, take care not to kink or stand on the hoses.
7) Fit blanks to all the adaptor test points.
8) Carry out the leak test procedure detailed in Section ADTS leak check.
9) If necessary carry out an altitude correction, see Figure 2-1 also.
NOTE: Read the whole procedure before starting the test process on an aircraft or
component.
To Next Page
Loading...
