GE AKTAprime plus User Manual

Viewing the run
When the pump starts running, the progress of the run can be viewed in the two panes
in PrimeView.
•
The Curves pane displays monitor signal values graphically.
•
The Logbook pane displays all actions (e.g. method start and end, base instructions
and method instructions) and unexpected conditions (e.g. warnings and alarms). The
log is saved in the result file.
Selecting curves to be displayed
1
In PrimeView module, select View:Properties.
2
In the Properties dialog, click the Curves tab.
3
In the Display curves list, select the curves you want to display.
4
Click OK.
For more information on customizing the view panes, see PrimeView User Manual.
40 ÄKTAprime plus Operating Instructions 28-9597-89 AB
4 Operation
4.4 Performing a run

GE AKTAprime plus Specifications

General

Pressure Range	0 to 5 MPa (0 to 50 bar)
pH Range	2 to 12
Software	UNICORN
Power Requirements	100-240 V, 50/60 Hz
Type	Chromatography System
UV Wavelength Range	190 to 700 nm
Conductivity Range	0.1 to 999.9 mS/cm
Detection Method	UV, Conductivity
Sample Loop Volume	5 µl - 5 ml (standard loops)
Pump Type	Dual Piston Pump