Why are there light leaks on my GE ImageQuant LAS 4000 Laboratory Equipment image?
If the ImageQuant LAS 4000 door is not completely closed, close it and expose the image again. Additionally, avoid direct sunlight to prevent light leaks on the image.
What to do if my ImageQuant LAS 4000 beeps and the Busy LED blinks?
If the door of the ImageQuant LAS 4000 is open, close it. The subsequent processing should then start.
Why is there unevenness seen on the image from my GE ImageQuant LAS 4000 Laboratory Equipment?
If you see unevenness on the image, check that both left and right Epi light sources are correctly in place and that they are of the same type. If a lamp in the UV trans illuminator is broken, turn the power off and contact your GE Healthcare representative. Also, make sure that the Flat Frame is correctly exposed, and if not, expose it again.
What to do if my GE ImageQuant LAS 4000 Laboratory Equipment camera head makes a strange noise, emits smoke or generates a strange odor?
If the camera head generates a strange noise, emits smoke or generates a strange odor, turn off the ImageQuant LAS 4000 power switch immediately and contact your GE Healthcare representative due to a potential camera head failure.
What to do if my GE Laboratory Equipment camera head emits smoke?
Turn off the ImageQuant LAS 4000 power switch immediately and contact your GE Healthcare representative.
What to do if my GE Laboratory Equipment camera head generates a strange odor?
Turn off the ImageQuant LAS 4000 power switch immediately and contact your GE Healthcare representative.
Why does the image appear misty on my GE Laboratory Equipment?
If the image appears misty, it may be due to dew condensation in the optical system. Quit the ImageQuant LAS 4000 Control Software and wait until the operation environment meets the required specifications.
Why is there noise on an image exposed using UV trans tray on my GE Laboratory Equipment?
If there is noise on an image exposed using a UV trans tray, it may be due to degradation of the UV trans tray. Purchase a new UV trans tray.
How to fix if an appropriate image does not appear on my GE Laboratory Equipment?
If an appropriate image does not appear, consider the following possibilities: * The image might be overexposed, so shorten the exposure time or check the iris setting. * The image might be underexposed, so lengthen the exposure time or check the iris setting. * The focus may not be correctly adjusted, so adjust the focus. * The tray, lens, or filter might be dirty, so clean them. * The wrong filter or lens might be installed, so install the correct ones. * The wrong sample tray might be used, so change to the correct sample tray. * The wrong light source might be selected, so select the correct one. * The Flat Frame file might not be exposed correctly, so expose it again. * The size of the object to be exposed might not coincide with the exposed area, so place the samp...
Covers critical safety instructions, intended use, and warnings for safe operation of the system.
Shows the main window of the control software and identifies key features and controls.
Outlines the steps for preparing the instrument and software before starting an exposure.
Describes how to select the correct tray and position samples for optimal image acquisition.
Describes methods for saving captured images, including file formats and options.
Guides users on selecting detection methods, light sources, filters, and tray positions.
Explains the process of creating correction files for CCD detector characteristics.
Details how to create a flat frame correction file for optical characteristics.
Step-by-step guide for installing the software on Windows XP systems.
Step-by-step guide for installing the software on Windows Vista systems.
General| Brand | GE |
|---|---|
| Model | ImageQuant LAS 4000 |
| Category | Laboratory Equipment |
| Language | English |
To Next Page
