Lt}
.o
13
Lt}
i
Lt}
O
Lt}
- V
f
I I!
iii_iii/iiiiii!li_i_i_!i
iiiiiltiiiiiiiii!iiiii_iiiiii
iiiiii_iiIilIilIim
i,...
0
E
0
Before you call for service...
Troubleshooting Tips
Excessivesmoking
Possible Causes
Excessivesoil.
What To Do
Touchthe Clear/Off pad. Openthe windows to
rid the room of smoke. Wait until the LOCKEDDOOR
light goes off.Wipe up the excesssoil and resetthe
clean cycle.
Ovendoor will not open
after a clean cycle
Oven too hot.
• Allow the oven to cool below locking temperature.
Donot lock the door with the door latch except when
using the self-cleanfeature.
Ovennot clean after a Oven controlsnot properly set. • Seethe Usingthe self-cleaning upper oven section.
cleancycle Oven was heavilysoiled. • Cleon up heavy spillovers beforestarting the cleon
cycle. Heavily soiled ovens may need to self-cleon
again or for o longer period of time.
"Door"appears in the Latch handlewas moved to the • Movethe latch handle to the right only when setting
display[onmodels right but a program other than the self-cleaning cycle.
with a door latch} self-clean was selected.
"LOCKDOOR"flashes
in thedisplay
Theself-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
wag to the right.
• Closethe oven door and on models with a latch, move
the latch all the way to the right.
LOCKEDDOORlight
ison when you wont
to cook
Theoven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
* Touchthe Clear/Off pad. Allow the oven to cool
and then, on models with a door latch,unlock the door.
"F--" and a number or On models with a door latch, • The latch may hove been moved,even if only slightly,
letterflash in the display if a function error code appears from the locked position.Hake surethe latch ismoved
during the self-cleaningcycle, to the right asfar as it will go.
check the oven door latch.
You have a function error code. • Touchthe Clear/Off pad. Allow the oven to cool for
one hour. Putthe oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. Ifthe function error
code repeats,call for service.
Ovenracks are The nickel racks (ifso equipped) • Apply a small amount of vegetable oil to a paper
difficult to slide were cleaned ina self-cleancycle, towel and wipe the edges of the oven racks with
Thegray porcelain-coated racks the paper towel. Do not spray with Pam®or other
(if soequipped)were improperly lubricant sprays.
cleaned.
"Probe" appears in This is reminding gou to enter a * Entera probe temperature.
the display [somemodels} probe temperature after plugging
in the probe.
LOCshows inthe
display
TheGas/Control Lockout feature • Besure the surface burner controls are turned OFF.
is activated. Turnthis feature off to use the range. Seethe Gas/Control
Lockoutsection.
54
To Next Page
Loading...
