GE Brivo OEC 865 - Page 467

Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
7-60
WKS Power on Button (5085810)
1. Power off system, and unplug the power cord form
socket.
2. Remove the rear and side covers of the Workstation.
3. Unplug the connector to connect WKS power on
button.
4. Release the secure ring and lock handle of WKS
power on button to Remove WKS Power Switch.
5. Replace a new one and connect the connector.
6. Assemble the Workstation front cover.
7. Connect the AC cord to the socket. Verify that Power
on Button is available.
8. Assemble all other Workstation covers.
MISC, C-Arm Key Switch (5085817)
1. Power off system, and unplug the power cord form
socket.
2. Remove the rear and side covers of the Workstation.
3. Unplug the wires connected to C-Arm Key Switch.
4. Release the secure ring of C-Arm Key Switch.
5. Remove C-Arm Key Switch and replace a new one.
6. Connect the AC cord to the socket. Verify that the
power on indicator will light.
Power on Indicator (P/N: 5085836)
1. Power off system, and unplug the power cord form
socket.
2. Remove the rear cover of the Workstation.
Lock Handle
Secure Ring
Secure Ring
Connector