GE Cync CSWONBLBWF1NN - Remove Your Old Switch; Ground Wire Requirement

Remove Your Old Switch
STEP 1
Remove the existing wall plate and switch from the wall.
STEP 2
Use voltage tester on the black wires to confirm power to
the switch is off (recommended).
STEP 3
Before disconnecting the wires from the wall, label each
with the provided wire labels.
Ground wire is required. If you don’t have this wire,
the Cync or C by GE Smart Switch is not compatible.
STEP 4
Disconnect wires and remove existing switch.
Line/Load Line/Load Ground
Wire Labels