GE Digital Energy User Manual

modications reserved 4 User manual ML Series 350-1000 VA UPS 1.0 (GB)
2.2 Installation Procedure
ML 350-700 ML 1000
1. Switch off your computer, and unplug it from the socket-
outlet.
2. Disconnect the power cord from the computer (rating
250Vac/10A) and connect this cord to the male input
socket (2) at the rear of the UPS (gures on the right show
simplied ML 350-700 model).
3. Using the output cord provided, connect the computer to
the appliance outlets (3) of the unit.
4. Connect the mains cord of the UPS to a working,
grounded AC wall socket outlet. The green LED ‘LINE’ will
blink now: mains power is available and the batteries are
charging.
5. For best results, allow the UPS to recharge the batteries
for a period of approx. 10 hours. It is acceptable to use the
UPS without rst charging the battery, but the runtime
may be reduced.
6. For advanced communication possibilities, the RS232
interface port (4) can be connected to a computer
system. See chapter 4.

GE Digital Energy Specifications