Need help?Do you have a question about the GE Druck DPI 705 Series and is the answer not in the manual?
General| Protection Rating | IP54 |
|---|---|
| Accuracy | Up to 0.05% FS |
| Display | LCD |
| Pressure Units | bar, psi, kPa, MPa, inHg, inH2O, mmHg |
| Pressure Media | Non-corrosive gases |
| Operating Temperature | 50°C |
| Storage Temperature | -20°C |
Details precision specs: non-linearity, hysteresis, repeatability.
Specifies temperature impact on span and zero readings.
States the limit for pressure safely applied to the device.
Describes the type and size of the pressure input connection.
Outlines the environmental protection rating (IP54).
Confirms compliance with EEC directives for essential protection.
Lists standards for emissions and immunity.
Specifies power source for non-certified units (3 x 1.5V AA).
Warning against exceeding maximum safe working pressure.
Instructions for battery removal, disposal, and safe storage.
Guidance on cleaning the instrument case with a damp cloth.
Directs to separate instructions for calibration and configuration.
Explains symbols for battery status, TARE, leak test, and alarm indicators.
Describes auto-off feature and how to disable it.
Details procedure for performing a leak test, including button presses.
Explains how to perform a zero adjustment for instruments.
Describes setting and managing pressure alarm function with alerts.
Details requirements for using the DPI 705 IS in hazardous areas.
Outlines marking details and installation compliance for hazardous environments.
Covers battery replacement, installation, special use conditions, and casing.
States design compliance with health/safety requirements and ATEX directive.
Notes that the instrument cannot be repaired on-site and must return to the factory.
Recommends an annual calibration check for 0.1% full-scale accuracy.
Steps to connect the instrument and select units for calibration.
Detailed steps for performing two-point compensation and changing the PIN.
To Next Page