To Next PageTo Next Page
Need help?Do you have a question about the GE Druck DPI 620 Genii and is the answer not in the manual?
General| Protection Rating | IP 54 |
|---|---|
| Type | Multifunction Calibrator |
| Measurement Parameters | Pressure, Electrical |
| Electrical Measurement Accuracy | Up to 0.005% Rdg |
| Display | Color LCD touchscreen |
| Battery Life | 8 hours typical |
| Communication | USB, Bluetooth, HART |
| Operating Temperature | -10°C to 50°C |
| Storage Temperature Range | -20 to 70 °C |
Lists items supplied with the DPI 620 Genii calibrator.
Details optional accessories for the DPI 620 Genii.
General guidelines for safe operation and handling of the instrument.
Important warnings regarding instrument usage and potential hazards.
Specific safety warnings related to electrical connections and power.
Critical safety warnings for pressure measurement and handling.
Step-by-step instructions for installing the instrument's battery.
Procedures and times for charging the instrument's battery.
Explains fundamental operational modes like Power On/Off and Sleep.
Overview of the instrument's various operational modes and capabilities.
How to navigate the instrument's touch-screen interface and menus.
Instructions for updating the instrument's software and firmware.
Introduces fundamental operations of the calibrator functions.
How to configure and use instrument function utilities like Max/Min.
Describes different ways to view measurement data on the display.
Demonstrates how to measure or source electrical current.
Demonstrates how to measure DC voltage and millivolts.
Shows how to measure AC voltage up to 20 Vrms.
Details measuring AC voltage using the AC probe.
Guides on sourcing DC voltage from the instrument.
Illustrates measuring and sourcing frequency signals.
Explains how to measure/simulate RTD sensors.
Guides on measuring/simulating thermocouple signals.
Lists and explains instrument error codes and symbols.
Identifies parts of the MC620 module carrier and PM620 pressure module.
Procedures for connecting external pressure equipment to the module.
How to configure and perform a leak test using the pressure module.
Instructions for zeroing the pressure module for accurate readings.
Configuration steps for initiating data logging.
How to start, stop, and manage data logging sessions.
Options for transferring, erasing, and checking memory status of log files.
How to use the analysis function for device calibration and testing.
Steps for executing downloaded calibration procedures.
Overview of accessing and using HART® communication functions.
Steps to launch and initiate HART® communication.
Explains the functions of icons in the HART® toolbar.
How to modify parameters and values within HART® devices.
Guides on running device-specific methods like self-tests.
How to initialize and begin FOUNDATION™ Fieldbus communication.
Procedure for searching and connecting to Fieldbus devices.
Explains the hierarchical structure for navigating Fieldbus device menus.
Tool for searching Fieldbus variables and device functions.
Configuration options for the Fieldbus application.
Preparation steps and environmental requirements before calibration.
Detailed steps for calibrating current measurement functions.
Detailed steps for calibrating current source functions.
Steps for calibrating DC millivolt and volt measurement.
Detailed steps for calibrating resistance measurement.
Steps for calibrating thermocouple millivolt functions.
Calibration procedures for pressure indicator modules.
Calibration procedures for the IDOS UPM.
Provides an introduction to the DPI 620 Genii's general specifications.
