User Manual Druck DPI620 Genii
2.2.2 Switch Test
This utility is available with measure or source
functions.
The additional values displayed show signal values
(measure or source) when the instrument detects a switch
opening and closing. The difference between the two values
is displayed as hysteresis value for the switch. This utility
can be used with Ramp Automation, where the rising signal
causes the switch to change state and the falling signal
causes the switch to resume its’ original state.
Figure 2-5 Switch Test Example
06 June 2013 K0541 issue 1 Page 39 of 175
To Next Page
Loading...
