EN-10 K319 Issue 2
Changing the ACCESS CODE
Leave the cursor at NONE at the measure and source menu and
press # and EXE simultaneously to open the set-up menu. Select
ACCESS CODE and press EXE.
Type in the access code and press EXE to confirm. You are now in a
mode where you can change the code. If applicable, the new code
can be typed in and confirmed by EXE. 0000 as code is considered
as no existing ACCESS CODE.
Note: Registration of the ACCESS CODE is essential.
Pressure Sensors
This menu enables the user to install and calibrate pressure sensors.
At the end of this manual, a special chapter describes the sensor
installation routine.
Calibration
This menu enables the user to calibrate and adjust the TRX-II. At the
end of this manual a special chapter describes the recalibration
routine. CALIBRATION menu is ACCESS CODE protected.
To Next Page
Loading...
