EN-26 K319 Issue 2
as a voltage adjustable and regulated DC supply. Frequency source
can take loads up to 32 mA at 24 Volts maximum.
Frequency source range 0-100 Hz
Go to frequency DIRECT mode to source any frequency signal
between zero and 100 Hz. Adjustments are made with 0.01 Hz
resolution.
Frequency source range 0-20 kHz
Go to frequency DIRECT mode to source any frequency signal
between zero and 20.000 Hz. Adjustments are made with1 Hz
resolution.
Pulse source range 0-6000 P./Min.
Same as 0-100 Hz but reads in Pulses/Minute.
Pulse source range 0 - 99 999 P./Hour
Same as 0-100 Hz but reads in Pulses/Hour.
Counter
Pulse source, preset number 999 999 999
max. Go to the pulse PRESET mode and
set the amplitude*. Press EXE to proceed
to the working screen. Use the and
keys to move the cursor from upper to
lower line and vice versa. Fill out the
number of pulses to be transmitted as well
as the Baud rate (max. 20 000 pulses/
sec). Press EXE to start pulse
transmission.
*Amplitude
24V maximum
12V maximum
To Next Page
Loading...
