GE Security
FHSD700C Series Product Guide
Table 3-3: Connections to RABBIT Processor Board
Connector Pin Description Description
8-pin RJ45 Standard Ethernet connections
Standard Ethernet cable.
Note: See Installation Guide for RS485 Equipment on page 36 for further details.
Table 3-4: Connections From 4 Channel Relay Board (Optional Module)
Output Relay Interface (i606)
1 C
2 NC
3
RELAY 1
NO
4 C
5 NC
6
RELAY 2
NO
7 C
8 NC
9
RELAY 3
NO
10 C
11 NC
12
RELAY 4
NO
Requires 7 x 0.2 - 6 A (24 AWG) cable.
Note: Maximum relay contact rating is 2 A @ 30 VDC.
Note: Please see 4-Channel Relay Module on page 31 for full operational details .
The following tables do not apply to the FHSD720C detector.
Table 3-5: Connections To Remote Panel (Optional) - from I620 Control Board
RS485 Remote Control Data
1 +24 VDC (Supply Out) Belden 9842 (24 AWG) cable (or equivalent)
2 0 V (Supply Common)
3 RS485 +
4 RS485 -
Note: Ensure that the Mid/End Jumper Link is fitted to the End position (pins 1 and 2 of CN 6).
Note: Please see Sections Remote Display Panel on page 15 and Installation Guide for
RS48
5 Equipment on page 36 for further details.
Note: Please refer to Section Remote Display Panel on page 15 for details.
www.gesecurity.net
13
To Next Page
Loading...
