GE GEH-ECG 1200 - ECG Cables and Accessories; Technical Specifications; 1200 W Acquisition Unit Specifications; 1200 WR Receiver Unit Specifications

ECG Cables and Accessories
Page 12 2102322-111 REV 1
ECG Cables and Accessories
Accessories
Part Number
Leadwires with Snaps IEC
2102322-011
Leadwires with Snaps AHA
2102322-012
Leadwires with Clips IEC
2102322-013
Leadwires with Clips AHA
2102322-014
Black belt for 1200W acquisition unit
2102322-015
USB cable 3m for 1200WR Receiver
2102322-053
BNC cable 3m for 1200WR Receiver
2102322-054
Technical Specifications
1200W (Acquisition unit)
ECG
Lead system
Standard 12 Lead
Patient Leads
Detachable 10 Lead wires conform to AAMI
Defibrillation protection
Protected against 360J discharge
Patient leakage current
< 10 uA
Input impedance
> 10 MOhm
CMMR
> 90dB
Frequency range
0.05 – 150Hz
Dynamic range
+/- 2.4V
Resolution
24 bits (0.286 uV/LSB)
Sample Rate Internal
8000
Sample Rate Recording
500
Lead OFF Detection
Yes
Communication
Digital RF
2400 – 2483 MHz,
0.4mW, conform to FCC Part 15.249
Power
Battery
Size AA x 2, Alkaline or NiMH
Operation time
Up to 40 hours with Alkaline Batteries
Mechanical
Size
140 x 95 x 50 mm
Weight
350g
Environmental
Operating Temp. Range
10 to 40 °C
Storage Temp. Range
-20 to 60 °C
Relative Humidity
10 to 95 % (non-condensing)
1200WR (Receiver)
Auxiliary output
ECG Out Bandwidth (-3db)
0.5 to 150 Hz
ECG Out Gain
1000
ECG Out Sample Rate
500
TTL Trigger width
16-128ms
TTL Trigger delay
<11ms (delay from R-wave)
Communication
USB
USB2.0 Full Speed
Digital RF
2400 – 2483 MHz,
0.4mW, conform to FCC Part 15.249
Power
USB 5V
100mA max at 5V input
Mechanical
Size
100 x 54 x 30 mm
Weight
80g
Environmental
Operating Temp. Range
10 to 40 °C
Storage Temp. Range
-20 to 60 °C
Relative Humidity
10 to 95 % (non-condensing)
Regulatory
Safety Standards
IEC 60601-1, 60601-1-2, 60601-2-25
Classification
Type CF with defibrillation proof. Internally powered
Certification
CE, FDA