Troubleshooting Tips
Save time and money! Review the charts on the following pages,
or visit GEAppliances.com. You may not need to call for service.
Before you call for service…
Problem Possible Causes What To Do
Dryer doesn’t start Dryer is unplugged • Makesurethedryerplugispushedcompletelyintotheoutlet.
HouseFuseisblown/circuit • Checkthehousefuse/circuitbreakerboxandreplacefuseor
breaker is tripped r
eset breaker. NOTE: Most electric dryers use two fuses/breakers.
Dryer fuse blown • Thesingle(Gas)oroneofthetwo(Electric)fusesintherearof
the backsplash blew because the house circuit protection didn’t
work. Have a qualified technician check for power at outlet.
Dryer doesn’t heat HouseFuseisblown/circuit • Checkthehousefuse/circuitbreakerboxandreplace
breakeristripped;thedryer both fuses or reset both breakers. Your dryer may tumble
may tumble but not heat if only one fuse is blown or one breaker is tripped.
Gas service is off • Makesuregasshutoffatdryerandmainshutoffarefullyopen.
No heat temperature selected • Selectanotherheatsetting.
Dryer shakes or Someshaking/noiseisnormal. • Movedryertoanevenfloorspace,oradjustlevelinglegs
makes noise Dryer may be sitting unevenly as necessary until even.
Greasy spots on clothes Improper use of fabric softener • Followdirectionsonfabricsoftenerpackage.
Drying dirty items • Useyourdryertodryonlycleanitems.Dirtyitemscan
with clean ones stain clean items and the dryer.
Clothes were not • Sometimesstainswhichcannotbeseenwhentheclothes
completely clean are wet appear after drying. Use proper washing procedures
before drying.
Lint on clothes Lint filter is full • Cleanlintscreenbeforeeachload.
Improper sorting • Sortlintproducers(likechenille)fromlintcollectors
(like corduroy).
Static electricity can attract lint • SeesuggestionsinthissectionunderStatic occurs.
Overloading • Separatelargeloadsintosmallerones.
Paper,tissue,etc.,leftinpockets • Emptyallpocketsbeforelaunderingclothes.
Static occurs No fabric softener was used • Tryafabricsoftener.
• Bounce
®
Fabric Conditioner Dryer Sheets have been
approved for use in all GE Dryers when used in accordance
with the manufacturer’s instructions.
Over-drying • Tryafabricsoftener.
• AdjustsettingtoLess Dry or Damp.
Synthetics,permanentpress • Tryafabricsoftener.
and blends can cause static
Inconsistent Type of heat • Automaticdryingtimeswillvaryaccordingtothetypeofheat
drying times used (electric, natural or LP gas), size of load, types of fabrics,
wetness of clothes and condition of exhaust ducts.
The Dry dryness level Load consists of a mixture • Whencombiningheavyandlightfabricsinaload,
was chosen but load is of heavy and light fabrics choose More Dry if you are using a sensor cycle.
still damp
Exhaust system is blocked • Inspectandcleanexhaustsystem.
14