What to do if there is low water flow in my GE GTW330?
If you're experiencing low water flow in your GE Washer, the water valve screens might be clogged. Turn off the water supply and disconnect the hoses from the back of the washer and the faucets. Clean the hose screens and the screens in the machine using a brush or toothpick. Reconnect the hoses, turn the water back on, and check for leaks.
Why is water siphoning out of my GE GTW330 Washer?
Water siphoning out of your GE Washer can occur if the drain standpipe is too low or the hose is inserted too far into the standpipe. The drain hose must exceed 30” in height at some point between the washer back and the drain pipe. Use an anti-siphon clip; refer to the Installation Instructions for guidance.
How to reduce suds in my GE Washer?
To reduce excessive suds in your GE Washer, consider the following: If you have soft water, use less detergent. Measure your detergent carefully, and if the load is lightly soiled, reduce the amount of soap. Also, consider switching to a High Efficiency detergent.
Why does my GE Washer have too many suds?
Excessive suds in your GE Washer can be due to several reasons. If you have soft water, use less detergent. You might also be using too much detergent in general, so measure carefully. Consider switching to a High Efficiency detergent.
Why is my GE GTW330 Washer making a squeaking sound?
A squeaking sound from your GE Washer may indicate that it is not level and is rubbing on the cabinet. To level the washer, adjust the leveling legs by rotating each leg in the proper direction until the squeaking stops.
Why are detergent packets not dissolving in my GE GTW330 Washer?
Laundry detergent packets should not be used in the dispensers of your GE washer. They should be added directly to the wash basket following the manufacturer’s directions.
What to do if water is siphoning out of my GE GTW330 Washer?
If water is siphoning out of your GE washer, the drain hose must exceed 30” height at some point between the washer back and the drain pipe. Use an anti-siphon clip and refer to the Installation Instructions for proper setup.
Why is my GE GTW330 Washer leaking water?
Several factors can cause water leaks in your GE Washer. You might be using too much detergent, or the wrong type. Try using less detergent, especially if you have soft water. Ensure your fill and drain hoses are properly connected and tightened at the faucets, with rubber washers installed. Also, check your household plumbing for clogs, and make sure the drain hose isn't rubbing against the wall. Finally, ensure constant water pressure doesn't stress the fill hoses, and consider replacing them every 5 years.
What to do if the water won’t drain from my GE GTW330?
If the water won’t drain from your GE Washer, check that the drain hose is not kinked or that the washer is not sitting on it. Ensure the top of the drain outlet is less than 8 ft (2.44 m) above the floor.
Why are clothes too wet after washing in my GE GTW330 Washer?
If your clothes are too wet after washing in your GE Washer, ensure that the selected cycle matches the load type. Some fabrics may feel wetter when rinsed with cold water. If the wash load is out of balance, redistribute the load and run it through a Drain & Spin cycle.
Instructions for environmentally safe disposal or recycling of the appliance.
Guidelines for correct installation, including electrical safety and start-up sequence.
Initial steps and overview of the washing machine controls and features.
Instructions for connecting the water supply hoses and the drain hose correctly.
Information on electrical connections, grounding, and a final checklist before operation.
Common problems and their possible causes and solutions to help resolve issues.
Overview of the warranty period, what is covered, and replacement policies.
General| Brand | GE |
|---|---|
| Model | GTW330 |
| Appliance Category | Washer |
| Washer Type | Top Load |
| Color | White |
| Number of Wash Cycles | 12 |
| Maximum Spin Speed (RPM) | 700 |
| Agitator | Yes |
| Energy Star Certified | No |
| Voltage | 120V |
| Width | 27 in. |
| Depth | 27 in. |
| Height | 44 in |
To Next Page
